Process design of strip and reel combination machine
To ensure the parallelism of the cotton roll, improve the uniform arrangement of the vertical and horizontal cotton roll, and avoid sticking, overlapping, broken edges, streaks and other phenomena. The drawing multiple of the strip and coiling machine should be reasonably configured, the compression pressure of the pneumatic compression components in each part should be accurately controlled, the difference of tightness between the inner and outer layers of the cotton roll should be minimized, and the edge of the cotton roll should be smooth and the layers should be clear.
In the process of use, the number of feeding roots after the machine should be reduced to ensure that the feeding strip after the machine is flush, there is no overlap and no leakage strip phenomenon when the double layer joint is parallel feeding, and the two sides of the cotton roll are flush without raw edge. The rolling can improve the phenomenon of sticking when the combing is rolled back. The process design should focus on improving the quality of cotton roll as much as possible, reducing the weight deviation, and selecting the appropriate optimal value of weight per meter and uniform value of weight per meter, which is the main focus of the process design of strip and reel combination machine.
The practice has proved that the cotton coil forming of the strip and reel combined machine is good, the number of feeding roots after the machine is properly reduced, the cotton channel is kept smooth and clean, the transverse width of the cotton coil is adjusted just, the friction of the cotton coil clamp on both sides of the end face is reduced, the side fiber adhesion can be effectively avoided, and the forming cotton coil is fed into the cotton feeding device of the combing machine in a correct and uniform way, which can improve the quality of the cotton strip. It plays an important role in reducing short lint and bent hook fibers.
The number of combined roots, the size of drafting multiple, the distance between rollers, feeding and output quantity are adjusted according to the actual situation of the spinning variety. The correct setting of strip coiling process has a great influence on the production and quality of the combing machine. The drafting multiple should not be too large and the number of feeding cotton strips should not be too much. Drawing multiple is too large and the number of feeding cotton sliver will cause the small roll adhesion increase, affect the quality of combing, cotton knot will also increase, so the drawing multiple should be smaller to master. Since 50% of the fibers in the carding strip are in the state of backbend hook, only the even-numbered configuration can change the direction of the backbend hook fibers to ensure that the fibers are better carded during combing. If the even-numbered design is not carried out, most of the backbend hook fibers will enter the falling cotton together with the staple fibers because they are not straightened by the carding in the forest, resulting in the waste of materials.
source:https://mp.weixin.qq.com/s/pMi3ku4claH8RUxQLk3qhA
